Cold light teeth whitening process steps Cold light teeth whitening technology to avoid the drawbacks of all previous conventional whitening methods, refuse to dull, calcified white, is currently the most healthy and effective teeth whitening method.
Cold light whitening process 1: Before the start of the cold light whitening operation, the dentist will conduct an oral examination and communicate with the whitening patients. People under 16 years of age, pregnant women and patients with severe periodontal disease will not be suitable for this type of cold light teeth whitening.
Cold light teeth whitening process 2: compare and record the color of teeth before whitening, can be photographed and archived, and whitening patients and operators wear goggles.
Cold light teeth whitening process three: polishing sand with a small amount of water, the surface of the teeth for a simple treatment.
After rinsing, be sure to dry the surface of the tooth.
Cold light teeth whitening process four: put wet insulation cotton into the inner lip, smear lip oil, wear cover paper.
Then put the mouth opener into the patient’s mouth to make sure the patient has no discomfort.
The light curing resin is then applied to the gums and covered up to 0 below the gingiva.
5mm, illuminated with a light curing lamp for about 3 seconds.
Cold light whitening teeth process five: the whole cold light lamp, the lamp should be 90 degrees vertical with the tooth surface, just contact the mouth opener.
. Mix hydrogen peroxide and whitening powder into a paste (note: the consistency should be lifted with a brush without dripping, not too thick). Apply the adjusted whitening agent on the surface of 16 or more teeth that have been blown dry, with a thickness of about 2-3mm.
Cold light teeth whitening process six: press the start button, start the first 8 minutes of treatment, after the end of the machine will automatically stop, and then use a strong straw to suck off the tooth surface whitening agent, if you need to use dry cotton ball to wipe the residual whitening agent on the teeth, do not rinse with water at this time.
Cold light whitening process 7: Repeat STEPS 8 to 10 twice for the second and third 8-minute sessions.
If the patient reports tooth sensitivity or pain, the cold light tooth whitening procedure should be stopped.
Cold LIGHT WHITENING TOOTH PROCESS EIGHT: USUALLY TWO 8 MINUTES OF TREATMENT CAN SEE THE OBVIOUS EFFECT, BUT WE propose TO FINISH 3 COURSES OF TREATMENT, IN ORDER to ACHIEVE THE MOST ideal RESULT.
After whitening, blot off the whitening agent, carefully remove the light-curing resin and sliver, rinse the teeth and interdental space with water, remove the mouthopener and goggles.
Cold light teeth whitening process nine: at this time need to do whitening teeth color, can be archived, the whole process is all over.
The above is the process of cold light whitening teeth introduction, so cold light whitening good?
Traditional cold light whitening has certain limitations, there will be teeth pain when whitening teeth, whitening after gingival allergy dilemma.
Teeth whitening technology, experts recommend blue light whitening.
Under the protection of the special gingIVA and tooth protection system, THE nano-photocatalyZED tooth activator with special optical treatment can establish the whitening action channel on the surface of the tooth, and the whitening ingredients can act directly on the tooth, and the residual pigment in the shallow, middle and deep layers of the tooth can be completely removed through the REDOX action.
At the same time, through fluorination, the enamel is promoted to regenerate, and the dentin tubules and enamel micropores are closed.
Not only whitening, efficient and lasting, but also bring brightness, firmness, to achieve the real health white – white, shiny, transparent sense.
This technique circumvents all the disadvantages of conventional whitening methods before, refusing dull, calcified white, is the most healthy and effective tooth whitening method.
